Here is the "PLAN" for reassembly and the completion dates

Dismantle completely to Frame 9/25/2004
Patch frame repair holes 1/15/2005
frame blast & paint 2/3/2005
Replace Gaskets/Seals rear differential air vents 7/25/2005
Replace Gaskets/Seals on front differential & vents 8/15/2005
Install skid plate 2/25/2005
Clean/Blast paint front/Rear springs 7/25/2005
Attach rear axle & springs to frame 9/10/2005
Attach front axle & springs to frame 9/10/2005
Install new brakes 9/18/2005
Install Tires/Rims 9/25/2005
Install battery tray 10/22/2005
Install tie rods 9/30/2005
Install Left Front Torque Spring 7/4/2006
Install Shocks 10/10/2005
Install Frame Axle Bumpers 5/6/2006
Install brake lines Front/Rear 9/24/2005
Install master Brake cylinder 5/5/2006
Build rotisserie 11/27/2005
Engine Rebuild and Install 2/14/2006
Replace thermostat 2/16/2006
Install Carburator 3/10/2006
Install Generator 3/11/2006
Install fan belt guard 3/12/2006
Install oil filler tube & dipstick 3/10/2005
Install oil filter 3/15/2006
Install Oil Lines 5/1/2005
Install battery & splash gaurd 5/1/2006
Install exhaust system 5/6/2006
Install Fuel Pump and Lines 1/20/2007
Install transfer case & mount 4/29/2006
Install emergency brake 12/30/2006
Install transmission 6/30/2006
Connect bell crank and drag link (Steering) 12/21/2006
Connect drive shafts and yokes 12/16/2006
Install steering column and wiring 12/21/2006
Install Engine pulley shield 12/28/2006
Install brake & clutch linkage 7/30/2006
Install yoke & throw out bearing 6/10/2006
Install flywheel & bushing 6/9/2006
Install clutch 6/18/2006
Install hand crank nut 12/30/2006
Connect accl linkage to engine 1/14/2007
Install starter 7/4/2006
Install distributor & wires 8/5/2006
Install coil 7/4/2006
Install radiator and fluids 12/21/2006
Install Engine Wiring 8/5/2006
.........start & run 1st time, verify Oil Pressure (30-40) and Temperature (180) 12/30/2006
Repair tub bottom (rusted spots with panels) 9/18/2006
Blast/Primer/Paint Tub 9/25/2006
Replace firewall pad 11/11/2006
Install wiring plan on Tub 12/9/2006
Install junction box and Dimmer switch on Tub 12/9/2006
Install main fuel line and add an inline filter 1/14/2007
Install main wiring harness & clips on Tub 12/9/2006
Install main light switch 12/2/2006
Install Radio Terminal box 2/1/2007
Install gauges amp, fuel, oil, temp, speedo on tub 1/1/2007
Install inner dash wiring 12/2/2006
Install rear panel wiring and clips 12/9/2006
Install Floor Starter on Tub (no room after tub install) 1/1/2007
Bleed brakes and test verify no leaks in lines 12/31/2006
Install Tub to Frame (after wiring and gauges hooked up) 1/1/2007
Bolt Down Tub to Frame 1/1/2007
Install Air Filter 1/15/2007
Install Choke and Throttle cables to Carb 1/13/2007
Install Emergency Brake Cable 1/5/2007
Install Gas Tank, Seals, and Fuel line 1/15/2007
Install Stay cable (Bell housing to frame) 1/5/2007
Install new Windshield glass with etching 2/19/2007
Install Battery Shield 1/5/2007
Install Grill and canvas liner 1/5/2007
Connect Speedometer to Transfer Case 1/4/2006
Install Horn and Wiring 1/15/2007
Complete wiring of Headlights, and Ignition 1/20/2007
Install Top Bow and hardware 2/19/2007
Install Steering column holder and canvas bushing 1/14/2007
Polarize Generator and regulator 1/15/2007
Install Driver, Passenger, Rear seats 2/19/2007
Install final coverings on Floor (tranny, steering, brake etc.) 2/25/2007
Install Spare Tire support 1/15/2007
**Test Start** Developed rear wheel brake cylinder leak - replaced 1/20/2007
**Test Start** Rear Main Seal oil leak - (fix) by replacing seal 2/4/2007
*** Test Drive *** Front Passenger Wheel Cylinder replaced 2/19/2007
*** Test Drive *** Timing was off, Tuned up 2/25/2007
Check Fluids, check for leaks (found some....) 1/15/2007
Install Canvas - ordered from Weebee 3/2/2007
*** Test Drive *** Front brake wheel cylinder stuck (Replaced) 2/17/2007
Check Bolts, Engine, Axles, Tub etc. for tight fittings 2/24/2007
*** Test Drive *** Brake adjustment - rims are warm - feel dragging 3/3/2007
*** Test Drive *** Valve adjustment verified .014 setting on valves 3/7/2007
*** Test Drive *** Carb vacuum check - adjusted 3/9/2007
*** Test Drive *** Regulator replacement - old sending 8.5 volts to battery 3/9/2007
Drive in parades, hook up with other G503 people!

Site Map